Commercial air-to-water heat pump with finned outdoor coils

클린룸 HVAC 및 공기 처리 장비

공기 - 물 열펌프 유닛

A reversible outdoor unit that produces chilled or hot water for cleanroom air-handling coils using one refrigerant circuit and ambient air heat exchange.

Reversible Heating and Cooling
Air-Source Heat Exchange
Integrated Hydronic Options
Seasonal Capacity Modulation

견적 요청 제품 찾아보기

상품 소개

The air-to-water heat pump reverses refrigerant flow so its water heat exchanger can either remove heat from the chilled-water loop or add heat to a hot-water loop. Outdoor finned coils exchange energy with ambient air, while scroll compressors and electronic expansion control adapt to seasonal conditions. The unit can serve four-pipe changeover coils, cleanroom support AHUs or low-temperature hot-water systems. Heating operation includes frost detection and defrost sequencing to restore outdoor-coil airflow.

주요 기능

One outdoor package supplies chilled water in cooling mode and low-temperature hot water in heating mode.

Reversible refrigerant circuitry reduces separate boiler and chiller equipment for suitable load profiles.

Variable or staged scroll compressors follow seasonal building demand and improve part-load control.

Integrated defrost management protects heating capacity as frost accumulates on the outdoor coil.

고객 제품 관심사

Air-source heating performance changes with outdoor temperature and frost, so water temperature, coil selection and backup strategy must be considered together.

Heating capacity falls during the coldest outdoor conditions.Equipment sizing considers low-ambient capacity and a staged supplemental heat source where required.

Defrost temporarily reduces delivered hot-water capacity.Buffer volume and coordinated multi-module sequencing limit water-temperature disturbance.

A high hot-water setpoint forces excessive compressor lift.AHU coils are selected for the lowest practical water temperature to improve heat-pump operation.

Flow stops while the outdoor unit remains exposed to freezing weather.Flow proof, freeze protection and an appropriate glycol concentration protect the water circuit.

일반적인 응용 프로그램

Cleanroom AHU heating and coolingLaboratory four-pipe changeover systemsMedical-device facilitiesPharmaceutical support buildingsLow-temperature hydronic heating

기술 매개변수

Typical outdoor enclosure and hydronic insulation data for a commercial air-to-water heat pump are shown below.

핵심 재료	Closed-cell EPDM elastomeric foam on outdoor hydronic piping and the plate heat exchanger
패널 두께	1.0–1.5 mm removable outdoor enclosure panels
유효 폭	900–2400 mm nominal equipment width
최대 길이	Up to 7500 mm for multi-circuit air-source arrangement
강철 면면 두께	1.0–2.0 mm galvanized base and weather enclosure
코어 밀도	60–75 kg/m³ closed-cell EPDM tube insulation
열전도도 (Thermal Conductivity)	≤0.041 W/(m·K) at 0°C for the EPDM insulation
표면 마무리	Outdoor powder-coated galvanized steel with coated aluminum finned coils available
접합 유형	Welded structural base with bolted service panels and grooved hydronic connections
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Cooling-only or reversible heat-pump operationFixed-stage or inverter scroll compressorsIntegrated pump, expansion vessel and buffer tankLow-ambient, low-noise and corrosion-protected coil packages

Planning a Air-to-Water Heat Pump Unit specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.