Three-quarter view of a knife-edge HEPA filter for gel-channel ceilings

エアフィルターと化学ろ過

ナイフエッジ HEPA フィルター

A mini-pleat HEPA panel with an integral perimeter blade that enters the gel channel built into a ceiling grid or terminal housing.

Integral Aluminum Knife Edge
Gel-Grid Compatibility
Common-Plenum Installation
Positive Perimeter Engagement

見積もりリクエスト製品案内

商品紹介

The knife-edge HEPA filter incorporates a thin continuous blade into the extruded-aluminum frame rather than carrying the gel on the filter itself. When the panel is lowered into a cleanroom ceiling grid or terminal housing, this blade enters the receiving gel trough and forms a fluid seal around all four sides. The mini-pleat media pack is potted within a separate frame cavity, and protective faceguards shield the filter during common-plenum installation. This configuration is especially useful where the ceiling grid retains the reusable gel channel and filter weight assists the sealing engagement.

主要な特徴

A continuous extruded knife edge presents one uninterrupted blade around the complete frame perimeter.

The blade engages the reusable gel channel built into compatible ceiling grids or equipment.

Filter weight and optional retainers maintain consistent penetration without crushing a foam gasket.

The sealing blade is physically separated from the potted mini-pleat pack to protect media integrity.

お客様の製品に関する懸念事項

Knife-edge filters require precise blade geometry and careful alignment so the complete perimeter enters the receiving gel without damaging the trough.

A replacement filter does not align with the reusable ceiling-grid gel trough.A dimensionally controlled extruded blade follows the modular frame perimeter and enters the specified channel centerline.

Sharp or rough blade joints tear the gel surface during installation.Smooth mitered corners and deburred continuous edges allow clean penetration around the full frame.

A shallow blade disengages when the ceiling grid deflects.The blade projection is matched to the gel-trough depth with sufficient engagement allowance.

Installers press on the media face while seating the perimeter blade.A rigid aluminum frame and protective faceguard provide safe load-bearing handling points.

典型的な用途

Common-plenum cleanroom ceilingsGel-channel fan filter units製薬生産スイートMicroelectronics cleanroomsTerminal housings with reusable fluid troughs

技術的なパラメータ

Typical construction ranges for an integral knife-edge mini-pleat HEPA filter are shown below.

コア材料	Low-pressure-drop microglass or expanded-fluororesin membrane media in a separatorless mini-pleat pack
パネルの厚さ	70-100 mm media frame plus 20-40 mm integral knife-edge projection
有効幅	305-610 mm ceiling-module width
最大長さ	Up to 1220 mm panel length
鋼鉄の厚さを直面する	0.45-0.65 mm optional epoxy-coated steel upstream and downstream faceguard
コア密度	Approximately 88-148 kg/m³ nominal knife-edge mini-pleat pack density
熱伝導率	Approximately 0.030-0.038 W/(m·K) for dry microglass or membrane media
表面仕上げ	Clear anodized-aluminum frame with a smooth deburred perimeter knife edge
ジョイントタイプ	Integral perimeter knife edge inserted into the gel channel of the matching ceiling grid or housing
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

H13, H14 or ULPA media20 mm or 40 mm blade projectionUpstream or downstream knife-edge orientationSingle-piece or reinforced long-format aluminum frame

Planning a Knife-Edge HEPA Filter specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する