Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Cleanroom équipement pièces de rechange
Z Damper actionneur
A compact direct-coupled rotary actuator that positions a matched AHU or ventilation damper through its shaft without a separate linkage assembly.
- Direct Shaft Coupling
- Visible 0-90 Degree Scale
- Manual Override Button
- Anti-Rotation Bracket
Introduction de produit
The damper actuator mounts directly on a round or square damper shaft and converts an electrical control command into controlled quarter-turn movement. A split universal clamp transfers torque to the shaft, while the separate anti-rotation bracket prevents the actuator body from turning with the drive. The visible angle scale supports setup checks, and the external manual-override control allows the coupling to be positioned when the selected model and operating instructions permit. Shaft geometry, required torque, rotation direction, supply voltage and signal type must all correspond with the installed damper and controller.
Key Features
The separate slotted anti-rotation bracket restrains the housing while allowing practical mounting adjustment.
A clearly marked angle scale and external override control support setup and service checks at the actuator.
A gland-protected multi-core lead keeps power and control conductors together for orderly equipment wiring.
Préoccupations du client produit
Dependable damper positioning requires the actuator torque, shaft interface and electrical control method to be selected as one compatible assembly.
An undersized actuator may stall before a large or tightly sealed damper reaches its commanded position.Required torque is assessed from damper area, seal friction, blade arrangement and the manufacturer's sizing allowance before the actuator is selected.
A replacement with the wrong control signal cannot follow the existing controller output.Supply voltage and on/off, floating or proportional input are matched to the installed control sequence and wiring.
An incompatible or poorly tightened clamp can slip on the shaft and lose blade position.Shaft shape, diameter, insertion length and clamp range are verified together, then secured with the specified fastening method.
Limited clearance or an incorrect restraint point can make the housing rotate or obstruct service access.The actuator orientation and anti-rotation bracket position are configured around the available AHU panel and shaft location.
Les applications typiques
AHU outdoor- and return-air dampersMixing and recirculation dampersVAV terminal and zone dampersVentilation isolation and control dampers
Paramètres techniques
Typical construction and dimensional ranges for compact direct-coupled rotary damper actuators are listed below.
| Matériaux de base | Durable engineering-polymer enclosure with copper-wound motor and steel gear and drive components |
|---|---|
| Panneau épaisseur | 45-90 mm nominal actuator enclosure depth |
| Largeur effective | 60-130 mm nominal actuator body width |
| Longueur maximale | Up to 260 mm overall body and anti-rotation bracket envelope |
| Acier face épaisseur | 1.5-4.0 mm zinc-plated steel clamp and bracket section thickness |
| Densité Core | Approximately 1100-1500 kg/m³ for the engineering-polymer enclosure |
| Conductivité thermique | Approximately 0.20-0.35 W/(m·K) for the engineering-polymer enclosure |
| surface finie | Matte black molded housing with zinc-plated silver shaft clamp and bracket, black cable and color-coded conductors |
| Type joint | Direct-coupled split shaft clamp with adjustable anti-rotation bracket and gland-protected wired connection |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
On/off, floating or proportional controlMatched 24 V or line-voltage configurationNon-spring-return or spring-return operationAuxiliary switch and feedback options
Planning a Damper Actuator specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
